Step 1: Remove the Empty Pod
Slide the empty pod and refill container upwards out of the top of your device. It should come away easily without much force. If it feels stuck, check that you are pulling in the right direction, as the pod only releases one way.
Step 2: Unbox Your New Pod and Refill
Take your new prefilled pod and refill container out of the packaging. Check both parts for any damage before you fit them together. This is also a good time to confirm the flavour and nicotine strength match what you ordered.
Step 3: Remove the Silicone Plug and Cap
Every refill container has a red silicone plug and a cap protecting it during shipping. Pull these off gently before use. Skipping this step is the most common reason a refill does not work properly, so do not rush it.
Step 4: Click the Pod and Refill Together
Line up the pod with the refill container and press them together until you hear or feel a click. This tells you the seal is secure and ready to transfer e-liquid into the pod without leaking.
Step 5: Insert Into the Device
Slot the combined pod and refill unit into the top of your Dojo Blast device. Most models have small arrows printed on the parts, so line these up to make sure everything sits the right way round.
Step 6: Take a Test Puff
Inhale gently on the mouthpiece. You should get a smooth draw with a clear hit of flavour straight away. If the first puff feels weak or dry, give the device a few seconds to let the e-liquid settle into the coil, then try again.
How to Refill a Vaporesso Dojo Blast 6000
The process for the Vaporesso Dojo Blast 6000 follows the same six steps above. This model pairs a 2ml pod with a larger 10ml refill container, so each refill lasts longer between changes.
Many users find this version the easiest one to start with, since the bigger container means less frequent swapping.
How to Refill a Vaporesso Dojo Blast 30K
The Vaporesso Dojo Blast 30K Pro uses two 2ml pods paired with two refill containers, so you simply repeat the same steps for the second pod once the first one runs out.
Because this model has a power mode switch, double-check it is set to your preferred mode after fitting a new pod, since some users accidentally knock the toggle during the swap.
Tips to Avoid Leaks and Dry Hits
• Always remove the silicone plug fully before fitting the pod
• Push the pod and refill together until you feel a firm click
• Store spare pods upright, not on their side
• Avoid pressing the pod into place at an angle, as this can damage the seal
• Wait a few seconds after inserting a new pod before taking a deep puff